Export of deformations to AutoCAD is new and highly desirable option when you are utilising STAAD/Pro. StaaDXF offers it now with minimum of required operations. You should only show your run file that went through the calculation phase and then, check off a request for export of deformations. At that time you could change scale factor and by that you could obtain a deformation shape that will present construction work. For each case of loading, you will get a separate layer. It is not highly necessary to mention that AutoCAD rulers enable examination of relative displacements in your model. The following screenshots will show you the easiness of StaaDXF's use for this operation, as well as achieved deformations within AutoCAD.
NEW Features : 
